PLEASE NOTE:

You will only receive what is pictured unless otherwise stated in the description. Please do not assume anything else will be included if it is not pictured.
All of the parts we sell are guaranteed to be in good working condition unless otherwise noted. We ONLY guarantee the part(s) will fit the vehicle(s) listed in the description. If your vehicle was not originally equipped with the EXACT part(s) listed, it is your responsibility to consult a dealer to see if it will fit your application. Additional items may be needed if this is an upgrade or custom installation. Please consult your local dealer for ALL other applications.

---

 

Important Information About Engine Warranty
(Warranty applies to parts that arrive defective/damaged or become defective within the warranty period)

What is Covered:
 Engine warranties are limited to manufacturing defects in the Engine Block, Cylinder Head(s), Head Gasket(s), Crankshaft, Pistons, Rods, Bearings, Oil Pump, Camshaft(s), Valves & Lifters.

  What is NOT Covered or Guaranteed to be included:
 The engine you receive may or may NOT include some additional accessories and extra parts. If included these parts are sold AS-IS with NO WARRANTY and were included to help protect the engine during storage and shipping. Examples of these non-warranty parts include switches, sensors, cables, coils, wires, injectors, electronics, belts (including timing belt/chain), hoses, water pumps, brackets, intake/exhaust manifolds, oil pans and turbos/superchargers (if equipped). To aid in installation, you get to keep your current engine and all attached accessories. Warranty does NOT cover labor, diagnostic, towing or rental car costs.

 Installation Check List:
(Failure to complete the following will void Warranty)
- Determine why the original engine failure occurred and make appropriate repairs.
- Insure this engine is the same application as the one being replaced.
- Clear all computer diagnostic codes from the vehicle prior to installing.
- Exchange the oil pan and pick up tube.
- Inspect and replace gaskets & seals (front seal, rear main seal, valve cover gaskets, oil pan gaskets).
- On crankshaft bolts that are drilled through sealant must be applied to avoid leaks.
- Install new thermostat & gasket (warranty will be void if engine heat tab is melted or removed)
- Replace the timing belt.
- Remove all cap-plugs orifice covers.
- Replace water pump.
- Install replacement sparkplugs & wires.
- Exchange the flywheel and bolts.
- Exchange attached accessory items to insure proper fit (mounts, intake manifold, exhaust manifold, distributor, sensors).
- Disable fuel/ignition before attempting to start engine. This will allow the oil to prime as indicated by the manufacturer.
- Replace engine oil, oil filter, air filter, fuel filters, coolant-antifreeze.
- Drain excess oil and coolant from exhaust system.
- If equipped with an engine oil cooler the radiator or external cooler must be replaced.
- Insure the cooling system is flushed and functioning properly.